How to use wood pellet machine properly.

How is the wood pellet machine properly applied? 

The wood pellet granule mold compression ratio refers to the ratio of the reasonable length of the ring die hole to the small diameter of the ring die hole, which is an index reflecting the extrusion strength of the wood chip. The greater the compression ratio, the stronger the extruded wood pellets. For the ring mode compression ratio of the straight hole, the reasonable length of the ring die hole is the total thickness of the ring die, and the small diameter is the diameter of the die hole itself.

For the release stepped hole and the outer tapered hole, the reasonable length of the die hole is the total thickness of the ring die minus the length of the discharge hole or the length of the outer taper hole, and the aperture of the small diameter section is the diameter of the compression ratio. For compression stepped holes and inner tapered holes, this situation is quite unique. Usually, the thickness of the whole ring mold is taken as the reasonable length of the die hole, and the diameter of the small diameter section is taken as a small diameter. In this case, the measured The meaning of the ring mode compression ratio is different from the first two cases.

The wood pellet machine current meets the specified load control, and it can never be overloaded for a long time. This is the key reason for the damage of the facility. In the whole process, it is necessary to ensure that the wood chip machine is close to the overload operation and can exert its better production. When the wood pellet machine is working, the feeding rate should not be too fast. After about ten minutes, the body starts to heat up, so that it can be fed without any problem, or it will cause blockage and high temperature. Before starting the machine, be sure to check whether the Shaanxi wood pellet machine oil dispenser is ok, the oil circuit is smooth, and prevent the high temperature from burning the bearings and other accessories.